www.bewet.fora.pl

tenl5yolsp

ke boosters are not for manual brakes. They are only used on power brakes to give more braking power with minimal pressure on the brake pedal. An [link widoczny dla zalogowanych][url=/parts/power-brake-booster.html]Acura brake booster[/url] is a device that provides extra braking power. They often work on vacuum pressure [link widoczny dla zalogowanych], but they also work in tandem with the master cylinder which holds the brake fluid to push brake fluid through the brake system.
How to install a brake booster?
First open the hood and locate the Acura brake booster. It will be attached to the [url=/parts/brake-master-cylinder.html]Brake Master Cylinder[/url] on the firewall. Loosen and remove the tube nuts holding the brake line to the master cylinder with the open-ended wrench. You can use a masking tape and a permanent marker to mark the location of where the brakes lines came from.
You will have to turn each tube nut counterclockwise to loosen and be especially careful that you do not damage the end of the nut while you are loosening it. Next [link widoczny dla zalogowanych], unbolt the two bolts holding the master cylinder to the brake booster and remove the master cylinder.
Then, unbolt the five or six nuts holding the brake booster in place under the dash behind your vehicles brake pedal. Then pull the retaining clip or pin in place using pliers then tap the pin out with the end of the pliers. Pull the brake booster out of the firewall and out of the engine bay. Lower the new brake booster into the engine bay where the old break booster.